Replacing Castor Wheel (6 inch wheel)
•
2 x 7/16 inch wrench
•
Oblong wooden block (at least 14 x 14 x 30 cm)
Removing Wheel
Fig. 6-40
1.
Loosen nut (2).
2.
Remove screw (6).
3.
Remove two washers (3) and (5).
4.
Remove wheel (4).
5.
Replace any defective parts.
Installing Wheel
1.
Install parts in reverse order.
2.
When installing wheel, pay attention to correct direction of rotation.
3.
Tighten nut to prescribed torque. See
6.10.4 Specific Tightening Torques, page 45
6.10.8 Replacing Castor Wheels on Single-Sided Fork
•
24 mm wrench
•
Oblong wooden block (at least 14 x 14 x 30 cm)
Removing Wheel
1.
Place wooden block underneath mobility device and prop up mobility device.
2.
Remove end-caps from bolt and nut (if applicable).
3.
Remove nut and washer from bolt.
4.
Remove bolt and wheel from fork.
Installing Wheel
1.
Install parts in reverse order.
2.
When installing wheel, pay attention to correct direction of rotation.
3.
Tighten nut to prescribed torque. See
6.10.4 Specific Tightening Torques, page 45
Replacing Castor Wheel (AVIVA RX, TDX SP2)
•
TX30 Torx key (TDX SP2)
•
TX40 Torx key (AVIVA RX)
•
Oblong wooden block (at least 14 x 14 x 30 cm)
1654647-B
51
