Invacare Aquatec Ocean Ergo, User Manual

Page: 15 / 224

Setup
WARNING!
Risk of injury due to damaged backrest buckles!
Check for secure fastening of the backrest
buckles each time the product is maintained or
reconditioned.
– Check all buckles for secure fastening by closing
the buckles and pulling on both ends.
– Replace the backrest/backrest buckles if a
buckle opens under the applied force.
4.2.3 Installing and Removing the Seat Plate
Installing
1. Place the seat plate on the seat frame with the cutout
to the front.
2. Press the seat plate down with the flat hand at the
sides and then at the front and back until the seat plate
snaps onto the seat frame.
Removing
1. Pull the seat plate upwards at the rear.
4.2.4 Adjusting the height of the armrests
1. On the backrest cover, open the third buckle of the belt
and loosen the other belts.
The nuts are inserted loosely in the securing clamp
and can fall out.
2. Unscrew the screws B of the armrest bracket A using
the Allen key supplied.
3. Remove the securing clamp D with the nuts from the
inside of the backrest frame.
4. Remove the backrest bracket A with the armrest and
move it upwards.
The smaller hole serves to fix the securing clamp.
5. Insert the screws in the armrest bracket and guide them
through the holes in the backrest frame.
6. If required, put the nuts back into the securing clamp.
7. Place the securing clamp on the backrest frame inserting
the fixation pin into the smaller hole.
8. Insert the screws into the nuts and tighten.
1639501-C 15