Invacare® Esprit Action® 4 NG
1.
To apply the brake, push the brake lever forwards as
far as possible.
2.
To release the brake, pull the brake lever backwards.
The lever of the push handle can be folded back to
facilitate transfers. To do so, pull up the lever and
fold it backwards.
WARNING!
Risk due to wheelchair being out of braking
control
In stiff slopes you can loose braking control of
your wheelchair and overturn.
– Do not take slopes exceeding 5° to ensure
perfect braking control of the wheelchair.
4.5 Comfort version
It is made up of a rigid shell
A
and a preformed foam
cushion
B
which is locked in place by Velcro® fasteners.
The backrest shell is removable to allow the folding of
the wheelchair. The comfort version is always delivered in
passive rear wheel position for a better stability.
WARNING!
Risk of injury
– Never lift the wheelchair by the backrest shell.
CAUTION!
Risk of pinching
– Keep your fingers away from movable parts
during folding, disassembling or adjustment.
Remove the backrest shell
1.
Slightly loosen the two hand screws
C
.
2.
Slide the levers
D
inwards until they are in open
position.
3.
Disengage the hooks
E
from their supports.
Install the backrest shell
1.
Engage the hooks
E
into their supports.
2.
Slide the levers
D
outwards until they are in lock
position.
3.
Firmly tighten the two hand screws
A
and makes sure
that the TWO hand screws
A
are properly tighten .
It is recommended that this operation be performed
only by the attendant. It is important to ensure that
the backrest shell is correctly fitted and engaged at
all times when the chair is in use. Make sure the
backrest cushion Velcro® fasteners are in good state
and well positioned.
38
1640502-B
Summary of Contents for Action 4NG series
Page 70: ...Notes...
Page 71: ...Notes...
