background image

Part No 1143248

1

21” Arm Pad for Walker Platform Attachment

For more information regarding Invacare products, parts, and services, 

please visit www.invacare.com

21” Arm Pad for Walker Platform Attachment

Model Nos. 1073913

NOTE:

 

Check

 

ALL

 

parts

 

for

 

shipping

 

damage.

 

If

 

shipping

 

damage

 

is

 

noted,

 

DO

 

NOT

 

use.

 

Contact

 

carrier/dealer

 

for

 

further

 

instruction.

Arm

 

pads

 

installed

 

on

 

the

 

Walker

 

Platform

 

Attachment

 

model

 

6027

 

may

 

not

 

be

 

suitable

 

for

 

all

 

arm

 

sizes.

 

Invacare

 

recommends

 

replacing

 

the

 

existing

 

17”

 

semi

adjustable

 

arm

 

pad

 

with

 

the

 

21”

 

fully

 

adjustable

 

arm

 

pad.

Safety Summary

To

 

ensure

 

the

 

safe

 

and

 

proper

 

installation

 

of

 

the

 

walker

 

platform

 

attachment,

 

these

 

instructions

 

MUST

 

be

 

followed:

 

WARNING

DO NOT install this equipment without first reading and understanding this instruction 

sheet. If you are unable to understand the warnings, cautions and instructions, contact a 

healthcare professional, dealer or technical personnel if applicable, before attempting 

to install this equipment - otherwise, injury or damage may occur.
Ensure that ALL attaching hardware is secure.
Invacare products are specifically designed and manufactured for use in conjunction 

with Invacare accessories. Accessories designed by other manufacturers have not 

been tested by Invacare and are not recommended for use with Invacare products.

 

INSTALLATION WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all 

attaching component parts are secure.

Installing the Arm Pad and Strap

NOTE:

 

For

 

this

 

procedure,

 

refer

 

to

 

FIGURE 1.

1. Remove

 

arm

 

pad

 

and

 

cover.

NOTE:

 

Note

 

the

 

orientation

 

of

 

the

 

existing

 

arm

 

strap

 

for

 

installation

 

of

 

the

 

new

 

arm

 

strap.

2. Pull

 

on

 

ring

 

and

 

remove

 

fastening

 

strap

 

through

 

the

 

slots

 

in

 

the

 

arm

 

support.

3. Thread

 

the

 

end

 

without

 

the

 

ring

 

of

 

the

 

new

 

arm

 

strap

 

through

 

slots

 

in

 

the

 

arm

 

support.

 

NOTE:

 

Make

 

sure

 

the

 

hook

 

end

 

is

 

facing

 

down

 

or

 

the

 

arm

 

strap

 

will

 

not

 

secure

 

properly.

4. Slide

 

the

 

arm

 

pad

 

and

 

cover

 

over

 

the

 

arm

 

support.

FIGURE 1   

Installing the Arm Pad and Strap

Assembly, Installation and Operating Instructions

SAVE THESE INSTRUCTIONS

Arm 

Support

Fastening 

Strap

Ring

Slots

NOTE:

 

Arm

 

pad

 

removed

 

for

 

clarity.

Reviews: