Open-Q™ 2500 Development Kit User Guide
Version 1.1
20
Copyright Intrinsyc Technologies Corporation
3.7.7
Debug Serial UART over USB J800
Figure 5 - Debug UART over USB
The UART connection used on the Open-Q 2500 is a USB micro B connector (J800). This debug
UART is available over USB via the FTDI FT232RQ chip on the carrier board. To get the serial
terminal working with a PC, user needs to ensure that the appropriate FTDI drivers are installed.
3.7.8
USB Type C (for ADB) J900
The USB connection on the Open-Q 2500 is a USB Type C connector (J900). This connection is
used for Android debug bridge (ADB) functionality. To get the adb shell, ensure that the board is up
and running and connect the Type C cable between the board and the PC. Type the command adb
shell on the PC prompt to exercise the adb shell functionality.
