Page 5 / 6
Page / Fitting and user guide for the EEN-REC3
V233-0013-AA receiver
Rolling code operation
The receiver manages the rolling codes emitted by the remote controls. They are intended to
counter attempts at making fraudulent copies of remote controls (through reproducing the
signal emitted by the remote control).
Every time a key on one of the remote controls is pressed, a code is emitted which must meet
criteria known only to the EEN-REC3 receiver. The security of your site is thus optimal.
It may be necessary to erase the rolling codes stored on the receiver. (Fitting the receiver
on another site for example). This erasure occurs at each power up or when switching switch
no.6 to the ON position (Then switch no.6 back to the OFF position).
Compliance with standards/ Limitations
EC standards:
The RF 868Mh EEN-REC3 receiver complies with the R&TTE Directive 1999/5/EC:
electrical safety standard EN 60950(2000) applied, EMC standard EN 301 489-3 (2000)
applied, radio standard EN 300 220-3 (2000) applied.
Cabling:
The cables used to connect the receiver to a central unit or GSM unit must be fitted in
accordance with the instructions describing the level 2, protected environment, of the NF EN
61000-4-4 standard.
Please follow the recommendations given in the cabling and connection diagrams, in
particular with respect to the distance and the gauge of the cables between the RF receiver and
the central unit or GSM unit. If this is not the case, no warranty will be given.
End of life product recycling:
The receiver and its accessories must not be disposed of with unsorted municipal
waste, but must follow the WEEE (Waste Electrical and Electronic Equipment)
collection and recycling channel.
