background image

Pair it with your phone

 

Make sure the headset is OFF.

 

Press and hold the power button until Blue and Red LED flash alternately to indicate the headset is in pairing 

mode. Voice remind " Power " on and then  " Pairing ".

 

Enable the Bluetooth service on your mobile devices and search or scan for the BT-950.

 

Select the device BT-950 from the list. Your device will pair automatically.

 

When the pairing is complete, the LED indicator will stop flashing quickly and revert to a slower flash in blue. 

Voice reminds "Pairing complete ".

Some phones may require a password, please enter 0000 to pair HM-BT950 successfully.

Already paired with the mobile phone use, only need to press and hold the multifunction key for about 2 seconds, 
blue lights flash twice, the voice prompt to boot, you can release the multifunction button, the headset will 
automatically connect back already paired Search phone, led the state for the blue lights flashing, if not find the 
phone has been paired, will enter pairing mode after 30 seconds.

Working status

 : when playing music, the headset will be with the red and blue flashing slowly.

Play / Pause

 : when music playing, click the multifunction key to pause music playing, and then click it again to 

play music. 

Missed calls

 : the headset connected to your phone, if there is telephone access, there will be voice hint to 

"distance calls," will as usual ringing ring tone, you can click the multifunction key or answer key phone calls, listen 
to End call, hang up also click the multifunction key, or via cell phone on-hook.

Shutdown

 

: when you don't want to use the Bluetooth headset, press and hold the multifunction key for more 

than 3 seconds. The Red LED will blink twice and the voice hint you "Power off ".

Power display

 

:

When the BT-950 is power on, click the battery indicator button, LED lights will show the color of power for 3 
seconds.

When the battery is running low, the red light will flash once every 20 seconds.

AUX-IN

 

:

In BT-950 working state, you can use the audio cable for your music device. At this point, the control functions only 
on the music device, BT-950 will not support any operating functions.

Battery indicator button

Status / Battery indicator light

Micro USB charger port

Red

Blue and red with bright 

purple mixed

Blue

Low Power

Medium Power

High Power

Summary of Contents for Jazz-BT950







Reviews: