(285PO) LED POOL SPRAYER ENGLISH SIZE: 4.875” X 7.25” 04/19/2020
English
285
PO
SAVE THESE INSTRUCTIONS
Page 2
General
• No tools are required for the assembly.
• Fits all round and rectangular Metal Frame and Ultra Frame pools (not suitable for Easy
Set, Oval and Panel pools).
• Built-in hydroelectric generator powers the LED light, no batteries or electrical
connection required.
• Lights in 3 colors: red, blue and green. Preset 10 seconds between color change.
Best seen at night or under low light condition.
• Pump flow rate required: 3,785
-
12,112 L/h (1,000-3,200 gph). System flow rate
required: 2,271- 7,570 L/h (600-2000 gph).
• Make sure the pump and the pool are setup and filled with water first.
• Remove the sprayer before placing a pool cover over the pool.
• When not in use remove from the pool and store in a safe place indoors.
• For pool and filter pump problems refer to their respective owner’s manual.
Setup
1.
Place the sprayer clamp over the selected horizontal top beam of the metal frame pool,
within reach of the filter pump return hose, and tighten the clamp screws by hand.
See fig 1.
2.
For filter pump with 38mm (1.5 in) hose and plunger valve:
a) Turn off the filter pump, close the inlet plunger valve, and disconnect the pump return
hose (from pump to pool) from the inlet plunger valve.
b) Attach the pump return hose directly to the sprayer inlet. See fig 2. Turn on the filter
pump.
FIG (1)
FIG (2)
