347
PO
S AVE THESE INSTRUCTIONS
(347PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 05/21/2020
English
Page 9
SET UP (continued)
Inflation
Inflate the Spa Tub Wall
1.
Take out the ground cloth
(19)
and spread it over the cleared area. Then spread out the spa liner over
the ground cloth and point the drain valve towards a suitable draining area.
NOTE:
Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
2.
Flip up the control base side cover
(4)
to reveal the air blower inflation outlet. Pull out the latch to open
the cover, insert the hose adaptor
(24)
with hose
and reattach the latch to the hose adaptor to secure it
in place
(see drawing 2)
.
2
1
2
3
4
5
3
7
1
2
4
3.
Unscrew the air valve cap on the spa tub to reveal the stem in the
up position for inflation. Insert the other end of the inflation hose
(7)
into the valve and turn to the right to lock it in position
(see
drawing 3)
.
4.
Press the button to turn on the control panel buttons first. Press
the
button to inflate the spa tub wall for 8 to 10 minutes until it
is firm to the touch but not hard
(see drawings 4 & 5)
.
IMPORTANT:
Do not over inflate or use high pressure air
compressor to inflate.
