114
SAVE THESE INSTRUCTIONS
Page 11
(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U
12/18/2006
TROUBLESHOOTING GUIDE
TT
RR
OO
UU
BB
LLEE
SS
HH
OO
OO
TT
IINN
GG
GG
UU
IIDD
EE
• Plug in the power cord.
• Switch the knob clockwise to the "I"
position to turn the electric pool
heater on.
• Re-plug the GFCI/RCD and press the
“RESET” button.
• The temperature sensor will cut off the
power of heater when the water
temperature is above approximately
95oF (35oC). It continues to work
when the water temperature drop
below approximately 82oF (28oC).
• Turn on the filter pump.
• Ensure the plunger valves are opened
(if any).
• Ensure your filter cartridges are clear
from debris and dirt.
• Release all trapped air in the
circulation line.
• Check for the direction of water inlet
and water outlet hose. Reverse the
hose if necessary.
• Always use the solar cover if the pool
is not occupied.
• Increase the heating time properly.
• Stop the heater and shorten the
heating time.
• Tighten/reinstall hose clamps.
• Reposition/replace hose seals.
• Unplug the GFCI/RCD and then
re-plug in and press the “RESET”
button to start the heater. Contact
Intex Service Center if it trips off
continuously.
THE RED
INDICATOR DOES
NOT LIGHT UP
DURING USE.
THE WATER
TEMPERATURE
DOES NOT
INCREASE
ALTHOUGH THE
RED INDICATOR IS
LIT UP.
THE WATER
TEMPERATURE IS
TOO HIGH.
HOSE LEAKING
GFCI/RCD KEEPS
TRIPPING OFF.
1. The power cord is not
plugged in.
2. The knob is not fully switched
to on position – “I”.
3. The GFCI/RCD plug is not
turned on.
4. The water temperature is too
high.
5. No water flow.
6. Low water flow.
1. Pool or solar cover not been
used.
2. The pool size or water capacity
exceeds the heater capacity.
3. The water temperature is too
low.
1. Heating time too long.
1. Hose clamps.
2. Hose seals.
1. Product failure or electrical
circuit problem.
PROBLEM CAUSE REMEDY
• The white inserts at both ends of the hoses shall remain inside and shall be
firmly inserted in the hose. Do not remove the white inserts from the hoses.
These white inserts are not serviceable parts.
• To facilitate the connection of the hoses into the black protruding hose
connectors on the pool wall, you may use soapy water solution (mix 6 drops
of dish detergent in 1/2 a cup of water) to lubricate the inserts by simply
dipping the hose ends into the solution. Continue per owner’s manual.
• Do not use lubricants such as machine or industrial oil or grease.
HOSE
INSERT
