170
PO
(170PO) RECHARGEABLE MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25” 05/16/2012
SAVE THESE INSTRUCTIONS
Page 1
(170PO) RECHARGEABLE MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25” 05/16/2012
SAVE THESE INSTRUCTIONS
Page 2
170
PO
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
INTEX
®
OWNER'S MANUAL
Rechargeable Multifunction LED Light 1 Watts Model CL1111
OPERATING INSTRUCTIONS
General
• This product is powered by an internal built-in rechargeable battery, however it can be operated from the external battery
pack using four (4) AA size batteries (not included) when the internal built-in battery is exhausted.
• Remove batteries from the external battery pack which is not to be used for an extended period of time.
• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium)
batteries.
• Remove used batteries promptly.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• The LED is a lifetime light source. It will never need to be replaced.
• The operating time for this product depends on whether it is run continuously or intermittently. Intermittent use extends the
operating time of a set of batteries.
• To clean the product, use only a damp cloth. Avoid strong cleaner, excessive water and abrasive brush.
Parts list
1. External battery pack (batteries not included)
2. Detachable 12V DC power cord
3. USB cable
Built-in battery indicator level and charging receptacles
The built-in battery indicator light and the charging input receptacles
are located on the left side under the rubber flap.
When the device is switched on and operating from the built-in battery
it automatically detects the built-in battery level as follow:
•
If the indicator light is flashing red the battery is about 40% level or
less, and requires charging.
•
If the indicator light is off the battery level is about 40% level or above.
Charging methods
The built-in battery indicator light will turn red when is in charging mode,
and green when is fully charged from either:
• A computer through the
USB cable
. It takes 5 to 6 hours
to fully charge the battery. (See Fig. 1)
• A vehicle 12V DC receptacle through the
detachable 12V DC power cord
.
It takes 2 to 3 hours to fully charge the battery. (See Fig. 2)
•
Adult use only. This product is not a toy, keep away from children.
• Do not stare directly at the light emitted by this product.
• The built-in rechargeable battery is not replaceable. Do not open, short circuit, or destroy the battery as injury may occur.
• Do not dispose of product in regular trash, municipal waste stream or by fire as the built-in rechargeable
battery may leak or explode.
• This product is resistant to rain and splashing water, but it is not submersible. Do not drop into or immerse in water.
WARNING
170-*PO-R0-1305
Fig. 1
Fig. 2
1
2
3
