IntesisHome® PA-AC-WIFI-1A
4
INSTALLATION GUIDE
4. Installation overview
5. Device connections
1. Unplug the Air conditioner (AC) unit from the power supply line.
2. Access to the main Printed Circuit Board.*
3. Locate the socket connector marked as CN-CNT*
4. Select a location for the IntesisHome device. See section 6 for more information.
5. Connect the A-end (the long one) of the supplied cable to the Air Conditioner CN-CNT connector and
the B-end (the short one) to the device AC connector.
6. Connect the external antenna into the antenna connector. Make sure you screw the antenna connector
in a clockwise direction until it stops.
7. (If needed) Install the Temperature Sensor. See section 8 for more information.
8. Place the antenna outside the AC, preferably in a vertical position and pointing directly to the Wi-Fi
Router or Access Point (AP). See section 7 for more information.
9. Close the Air Conditioner unit.
10. Plug the AC to the power supply line. If connection with the Air Conditioner has been successful, Inte-
sisHome device LED will start blinking Green and then will change to steady Green.
* See Panasonic installation or service manual for detailed information.
Figure 2
1. IntesisHome device
2. External antenna
3. Wi-Fi Access Point or Router
4. CN-CNT
5. Temperature Sensor
Summary of Contents for PA-AC-WIFI-1A
Page 47: ...RU...
