Intesis
Box
®
ASCII Server
– KNX
User Manual r1.0 EN
© Intesis Software S.L.U. - All rights reserved
IntesisBox
is a registered trademark of Intesis Software SLU
15/20
email:
web:
phone: +34 938047134
•
Communication type
: Select if ASCII communication will be through TCP/IP, serial (EIA232 or EIA485) or
both.
•
Notification on ASCII Value:
Gateway will allow sending spontaneous messages to the ASCII bus when a
change of value is received in the KNX side.
•
Answer required for write commands:
If enabled, the gateway will send back an OK message to the ASCII
master device.
•
Define custom string commands:
Define the special character to be used to read or write the internal gateway
datapoint.
•
Port:
TCP port to be used for the ASCII communication. By default, it is set to 5000.
•
Keep Alive:
Time of inactivity before sending a keep alive message.
o
0:
Disabled
o
1
…1440:
Possible values expressed in minutes. By default, it is set to 10.
•
Connection type
: Physical connection, between EIA232 and EIA485 can be selected.
•
Baud rate:
Selectable from 1200, 2400, 4800, 9600, 19200, 38400, 56700 and 115200.
•
Data type:
o
Data Bits: 8
o
Parity can be selected from: none, even, odd.
o
Stop Bits:1 and 2
5.2.4 Signals
All available objects, Object Instances, its corresponding ASCII register and other main parmaters are listed in the
signals tab. More information on each parameter and how to configure it can be found in the IntesisBox MAPS user
manual for ASCII.
Figure 5.4
IntesisBox MAPS Signals tab
