Remote light switch module ITLM-1000
Operating and installation instructions
The remote light switch module is used for remote controlled switching
of all lamps and electronic devices with a total power not exceeding 1,000 Watts.
LED and energy-saving bulbs up to 120 Watts. Fluorescent tubes up to 300 Watts!
Compatible with all intertechno radio transmitters manufactured in 1995 or later.
Handheld remotes, wall-mounted transmitters, motion detectors, twilight switches, timers,
etc.
Installation
Power connection is established as shown in
Fig. 1
and must
be carried out by a licensed electrician.
1.) Disconnect fuse!
2.) Phase L and the neutral conductor N are connected to the designated
screw terminal.
The two white cables are connected directly to the light switch (do not use any push-button
switches) and may not be connected to the electrical supply.
ITLM-1000 can also be easily incorporated into the line feed to the consumer
without using a light switch. To do this, you only need to isolate the white cables.
Do not cut them in any way!!! (They also serve as an antenna)
Encoding
Fig. 2
Follow the respective operating instructions of the transmitter.
1.) Connect fuse.
Prepare desired IT transmitter.
2) It is possible to press the LEARN BUTTON (L) on the receiver shortly (approx. 0.5 s)
to switch on and off, for checking purposes.
Summary of Contents for ITLM-1000
