www.intertec.info
Mounting Instructions Insulation adapter ISOPASS
KMI111379595Ien-1
Page 3 / 6
INTERTEC-Hess GmbH · Raffineriestr. 8 · 93333 Neustadt/Donau · Germany ·
+49 9445 9532-0 · [email protected]
1
Information and regulations to be
complied with
The following must be complied with:
• The contents of the assembly instruc-
tion and assembly instructions of the
individual components,
• the safety information attached to the
product and individual components,
• the generally applicable safety
guidelines for the installation and op-
eration of electrical systems,
• the generally applicable safety
guidelines for handling gases, dusts
and condensate.
2
Explanation of symbols for warnings
and signal words
The safety information warns the user about risks and
provide information on how risks can be avoided.
Safety information can be found at the start of the
chapter before the instructions which may lead to a haz-
ardous situation. Additional safety information can be
found at the beginning of this manual.
Safety instructions which must be adhered to are high-
lighted as follows:
DANGER
DANGER
This sign is warning about an extremely hazardous situ-
ation which, if not heeded, will lead to death or serious ir-
reversible injury.
WARNING
WARNING
This sign is warning about a hazardous situation which,
if not heeded, may lead to death or serious irreversible
injury.
CAUTION
NOTICE
This sign is warning about a hazardous situation which,
if not heeded, may lead to slight, reversible injury.
NOTICE
NOTE
It is essential to pay attention to this safety advice as you
may otherwise incur material damage.
INFO
Important notes and useful additional information.
3
Safety information
3.1
Prerequisite for Safe Operation
To ensure perfect and safe operation of the product and
its components, it must be transported and stored prop-
erly, installed and set up correctly as well as operated
and maintained carefully as intended.
3.2
Qualifications of the Personnel
Only qualified personnel familiar with the installation, set-
up, operation and maintenance and who have the ne-
cessary qualifications for their tasks may work on the
product and its components.
3.3
National Regulations
All national, state, regional and local regulations, codes
and standards must be observed during installation of
the product.
3.4
Safety of the Product and safe Operation
The product has been constructed and tested in compli-
ance with the relevant regulations and safety standards
and has left our factory in perfectly safe technical condi-
tion. To maintain this condition and to ensure safe oper-
ation, the operating instructions must be observed.
4
Technical Data
Material
PU rigid foam
Type 1016 and type 1016D
Length x Width x Height
200 x 104 x 150 mm
Type 1018 and type 1018D
Length x Width x Height
224 x 110 x 240 mm
Type 1320 and type 1320D
Length x Width x Height
246 x 134 x 168 mm
