INTERSPORT POWER RUN 1.1, Manual

Page: 12 / 73

12
BELT ADJUSTMENT
The treadmill is properly centered by the factory. However, after a long usage you must check to make
sure the treadmill is still centered on the running deck and that it still runs with enough tension to ensure
a smooth run. If this is not the case, the treadmill has to be adjusted.
•To do this, proceed as follows: If the treadmill is running to far to the left, the turn the left screw
clockwise so that the band will be adjusted to the right. If the problem is not corrected after doing this,
then please turn the right screw as well, but counter clockwise, until the band is the middle and has the
correct tension.
•If the bank is in general too loose (fluttering), then turn both screws clockwise using the hexagon
wrench until it is tighter. If you notice that the band “wanders” to the left or the right during training, then
repeat the adjustment procedure and re-center it.
•Depending on the circumstances, this could be necessary a few times.
Warning: When adjusting the band with the screws, do it carefully and with as few turns as possible
because over tightening the screws could result in damages of the plastic end caps. Check the location
of the band during the centering procedure by walking a little bit in between adjustments.
If the band has been correctly adjusted, it will be sufficient to check the position in regular intervals of
several weeks.
In addition, the correct centering must be checked after each time the treadmill is folded up as well as
after every transport.