Preliminary OEM installation manual
FCC ID: OSZ37704M
Page 10 of 11
2.5 Export restrictions:
This product or software contains encryption code which may not be exported or transferred from the US or
Canada without an approved US Department of Commerce export license.
2.6 FCC Guidelines for Human Exposure
SAR (Specific Absorption Rate) for this device was measured in accordance with FCC OET Bulletin 65
(Supplement C) and guidelines established in IEEE C95.1-1991. Based on these measurements, this device fulfills
the SAR limits for general population / uncontrolled exposure
Caution:
In order to comply with RF exposure limits established in the ANSI C95.1 standards, the user is advised
to maintain a distance of at least 1.0 cm from the antenna of this device while it is in use.
If the antenna is positioned less than 1.0 cm from the user, it is recommended that the user limits the
exposure time.
2.7 Europe - EU R&TTE Declaration of Conformity
This Wireless LAN Radio device is tested to and conforms with the essential radio test suites included in following
standards:
Standard
Description and Explanation
LVD specification
EN 60950
EN 60950,ed. (1992), incl. A1(1993), A2(1993), A3(1995) and
A4(1997)
Safety of information technology equipment, including electrical
business
equipment.
Meets R&TTE directive art. 3.1.a of essential requirements on protection
of the health and safety of the user.
ETSI EMC specification
ETSI EN 301 489
Part 1 V1.2.1 (2000-08)
Part 17 V1.1.1 (2000-09)
Electromagnetic compatibility and Radio spectrum Matters (ERM);
Electromagnetic Compatibility (EMC) standard for radio equipment and
services;
Part 1: Common technical requirements
Part 17: Specific conditions for Wideband data and HIPERLAN
equipment
ETSI RF specification
EN 301 893
V1.1.1 (2001-01)
Broadband Radio Access Networks (BRAN), HIPERLAN Type 2
Harmonised EN covering essential requirements of article 3.2 of the
R&TTE Directive
Table 03: EU RTTE Compliance specifications
and therefore complies with the essential requirements and provisions of the Directive 1999/5/EC of the European
Parliament and of the council of 9 march 1999 on Radio equipment and Telecommunications Terminal Equipment
and the mutual recognition of their conformity and Annex IV (Conformity Assessment procedure referred to in
article 10(4)).
Important Notice :
This device is a 5 GHz low power RF device intended
for home and office use in EU and EFTA member states.
In some EU / EFTA member states some restrictions
may apply. Please contact local spectrum management
authorithies for further details before putting this device
into operation
EU versions of this Indigo WLAN device only have 4 channels in 5150-5250MHz band with RF output power
limited to 50 mW. This device is intended for indoor use only.
