Interroll Transfer module SH 1400
Product identification
14
Version 1.0 (06/2022) en
Translation of original operating instructions
Property
The transfer module can be used with horizontal module belt conveyors. It can be installed at
any position along the conveyor path. A subsequent installation is possible, as is shifting. No
supports are attached at the module since it is connected straight with the module belt conveyor,
which is standing on supports.
The drive is provided by an Interroll RollerDrive EC5000. Together with MultiControl, it is very
easy to implement a zero-pressure accumulation conveyor.
Depending on the size of the transfer module, the rated width is S (410 mm), M (715 mm) or L
(867 mm).
Technical data
SH 1400
Rated width (BF)
410 mm (S)
715 mm (M)
867 mm (L)
Conveying width (CW)
398 mm (S)
703 mm (M)
855 mm (L)
Dimensions of conveying good
Min.: 100 x 100 mm
Max.: 700 x 800 mm
Max. load capacity
35 kg/m
Conveyor speed
0.1 to 0.8 m/s
Ambient temperature
–5 to +40 °C
Incline/decline
Not suitable
Module length
310 mm
Conveying height (TOB)
Preselected in the layouter
Motor type
RollerDrive EC5000
Electrical power
35 W
Rated voltage
24 V
Rated current
2.4 A
Starting current
5.5 A
Control variants
MultiControl Bus Interface (IPX5 housing)
Transmission of force
Sprockets
Module conveyor
Movex 510FT
Protection rating
RollerDrive: IP 66
