Interroll Pallet Control PC 6000
Safety
8
Version 2 (02/2020) en
Translation of original operating instructions
Personnel qualification
Unqualified personnel cannot recognize risks and, as a result, is subject to greater dangers.
4
Authorize only qualified personnel to perform the activities described in these instructions.
4
The operating company must ensure that personnel follow locally applicable regulations and
rules about safety and hazards while working.
The following target groups are addressed in these instructions:
Operators
Operators have been instructed in the operation and cleaning of the product, and follow the
safety guidelines.
Qualified person
A specialist is a person who, based on his relevant technical training, education and experience,
is capable of detecting risks and avoiding dangers that could occur during the use of the
product.
Electricians
An electrician has technical training and, based on his or her knowledge and experience, as well
as knowledge of relevant provisions, is capable of properly performing work on electrical
equipment. He or she can independently recognize potential dangers and avoid personal injury
and property damage from electrical voltage.
In principle, all work on electrical equipment may be performed only by a trained electrician.
Dangers
The following list provides information about the various types of danger or damage that may
occur while working with the Pallet Control.
Bodily injury
4
Work on the device must be performed only by authorized electricians in accordance with
applicable regulations.
4
Before using the product, ensure that no unauthorized personnel is in the vicinity of the
conveyor.
Electricity
4
Only perform installation and maintenance work when powered down.
4
Before working on the device, ensure that both voltages (400 V AC and 24 V DC) have
been switched off.
DANGER! 400 V could be applied even though the LEDs are not
lit. This occurs if only the 24 V DC control voltage was switched off and the power
supply voltage continues to be applied.
4
Secure the device against inadvertent activation.
Working environment
4
Do not use the product in explosive environments.
4
Remove material that is not required and unnecessary objects from the workspace.
Faults during operation
4
Regularly check the product for visible damage.
4
If you notice smoke, switch off the power immediately and ensure that it cannot be switched
on again accidentally.
4
Immediately contact an electrician and have that person determine the cause of the fault.
