Interpack CE-12P, Operations Manual & Parts List

Page: 17 / 43

CE-12P Manual 17
USM8131
8 TROUBLESHOOTING
Interpack Carton Sealers are fabricated with high quality components that provide
trouble-free operation for a long period. However, should a problem occur, we
recommend that you consult the following table before calling for service. If the problem
you encounter is not discussed in this table, call Intertape Customer Service
Department (see section 1.1 of this document).
FAULT TROUBLE POSSIBLE CAUSES SOLUTIONS
01 Low Air
Pressure The air is not connected
to pressure source or no
compression air.
Air pressure is no
enough.
Manual valve is not
open.
Connect to compressed
air.
Set air to 80 psi
minimum.
Open air valve.
02 Not in Initial
Position Door was opened during
machine cycle or
emergency stop button
was depressed. Close doors or clear
emergency stop buttons,
press “Cycle On” button
and “Manual Reset”
button.
03 Vacuum not
detected The inner filter of
Vacuum Inspection
needs to be clean.
Vacuum Cup is sucking
on the folding line.
Clean vacuum assembly.
Adjust vacuum cup
positions.
04 Hopper Empty No carton. Stop and supply carton.
05 Carton
withdraw failure Wrong Cup position.
The motion of front / rear
/ left / right flap folding is
not precise.
Adjust Vacuum Cup and
Up/down stopper to
adequate position.
Adjust front / rear / left /
right flap folding
mechanism.
06 Carton Jam Left / right belt is too
wide or too narrow.
Upper working table is
too low.
Carton Pushing Arm
Jammed
Adjust Left / right belt.
Adjust upper table.
Clear Jam