Co d e 39
10
3. Make sure the scanner is on
and the cable is secure and
then place a bar code right-
side up over the label on the
base of the stand.
When you get a successful
read the laser beam turns
off, the scanner beeps once,
and the light turns green.
If you remove the scanner from the stand, it will immediately
reset to hand-held scanning. You can scan bar codes by pressing
the trigger.
Configuring the Marker Beam
This section explains how to configure the marker beam on
long-range and high-visibility scanners. Scan one of the
following bar codes to turn off the marker beam, set it to appear
for 500 milliseconds, or set it to appear for 1.25 seconds. The
default setting is 500 milliseconds.
Off
500 milliseconds
1.25 seconds
155XQG.004
*HI*
