158--01963
LIMITED ONE-YEAR WARRANTY
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge.
This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse
in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with
instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED’s and batteries; (f) the finish on any portion of the product, such as surface and/or
weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR
IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE
HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME
STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.
intermatic.com. This warranty is made by: Intermatic Incorporated, Customer Service 7777 Winn Rd., Spring Grove, Illinois 60081-9698. For warranty service go to: http://www.
intermatic.com or call 815-675-7000.
TROUBLESHOOTING
Symptom
Possible Cause(s)
Corrective Action
No response to ON/OFF button on receiver.
(No click, controlled device does not
operate.)
No power to receiver black and white wires.
Check for tripped circuit breaker at power
panel. Verify that receiver is correctly wired.
Faulty receiver.
Replace receiver.
Controlled device is always ON and can’t be
turned OFF by the ON/OFF button on the
receiver.
Receiver is wired incorrectly.
Correct per installation diagram.
Faulty receiver.
Replace receiver.
Receiver clicks when its ON/OFF button is
pressed, but the controlled device doesn’t
operate.
The controlled device is inoperative. Perhaps due
to a switch, thermostat, etc. on the controlled
device.
Determine what is preventing the correctly
powered device from operating.
Receiver is wired incorrectly.
Correct per installation diagram.
Faulty receiver; never any voltage output from red
wire.
Replace receiver.
Transmitter LED doesn’t light when buttons
are pressed.
Low battery.
Replace CR2032 battery.
Faulty Transmitter.
Replace transmitter.
Transmitter LED lights when buttons are
pressed and ON/OFF button on receiver
functions, but transmitter does not cause
receiver to operate.
Transmitter button(s) and receiver are not correctly
linked.
First, try all 3 buttons on (all) transmitter(s).
Repeat the steps of “Linking RC939 Transmitter
to RC613 Receiver” to correctly link the desired
transmitter button to the receiver.
Faulty transmitter and/or receiver.
If possible, test with known good components,
then replace as required.
No response to transmitter signal some
times.
Weak battery.
Replace battery.
Appliance with brush type motor is in use.
Relocate appliance and/or connect to another
circuit.
Other radio transmitter (police, etc.) is operating
nearby.
Link a different transmitter button with the
receiver (see page 3, Operation instructions).
Receiver is at edge of range.
Mount receiver closer or higher.
Insufficient Range.
Weak battery.
Replace battery.
Antenna too close to ground.
Relocate receiver module.
Transmitter is held too close to ground.
Hold transmitter at least 3 ft. above ground.
Weak signal due to obstruction.
Remote/relocate receiver module.
Nuisance operation.
Other radio transmitter (police, etc.) is operating
nearby.
Link transmitter button with the receiver (see
page 3, Operation instructions).
Fluctuating supply voltage due to surge, etc.
If frequent, install surge suppressor.
Faulty receiver.
Replace receiver module.
Because of our commitment to continuing research and improvements, Intermatic Incorporated reserves the right to make changes, without notice, in the
specifications and material contained herein and shall not be responsible for any damages, direct or consequential, caused by reliance on the material presented.
INTERMATIC INCORPORATED
Spring Grove, IL 60081-9698
www.intermatic.com
