MODEL: IR6-600WH
LED Recessed Downlight for 6” Retrofit Applications
120VAC 60 Hz, 0.11A, 13.7W
Suitable for damp locations
INSTALLATION INSTRUCTIONS
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations by a person
familiar with the construction and operation of the product and the hazards involved. To assure full compliance with local
codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off
electricity at the breaker before proceeding. Retain these instructions for future reference.
• Install this kit only in luminaires that have the construction features shown in the photographs and/or drawings.
• Do not attempt to install or use the IR6-600WH module until you read and understand the installation
instructions.
• Verify power is off before installing or un-installing.
• Do not use the IR6-600WH if the lens, housing, or power cables are damaged.
• IR6-600WH must be installed in a 6” IC or non - IC recessed downlight. See UL Approved Housing list.
• The IR6-600WH has no user serviceable parts. Do not attempt to open this product.
• Do not exceed 120VAC and 60 Hz.
• Do not replace module with power on.
• Avoid looking directly into light beam as the high brightness beam may damage the eyes.
• Do not repair or modify this product.
• The LED lighting source is not waterproof. For high humidity use, this lighting source must be used in a fixture
with IP65 rating.
• To prevent wiring damage or abrasion, do not pinch or damage exposed wiring during installation. Keep wiring
away from edges of sheet metal or other sharp objects.
WARNING
Risk of Fire, Electrical Shock or Personal Injury
1. Remove IR6-600WH and Edison-style socket
adapter from carton.
2. Remove existing trim and CFL or Incandescent
bulb to reveal the screw-in Edison-style socket.
If the recessed housing has a socket plate,
remove the socket plate from the recessed
housing, then disconnect the socket plate from
the socket and dispose of plate.
3. Connect the Edison-style connector to the
recessed housing socket (as shown in Figure 1).
NOTE: If a different style socket is already
mounted, confirm the housing is UL Approved
for the LED module.
4. Connect the included Edison-style connector to
the IR6-600WH module (as shown in Figure 2).
5. Squeeze torsion springs together and install into
torsion spring brackets inside recessed housing
(as shown in Figure 3).
NOTE: If housing does not have torsion spring
receivers, replace housing with one that is
compatible with LED module (see page 4
for UL Approved Housing list).
6. Carefully route wires into fixture and push
module up flush to ceiling surface (as shown in
Figure 4).
Figure 2 - Connect Edison-style
connector
Figure 1 - Secure Edison-style
Connector by screwing into socket
Figure 3 - Squeeze torsion springs
and insert into recessed housing.
Figure 4 - Carefully insert module into recessed housing.
