2
Digital Landscape Timer
INITIAL SETUP
Overview
Upon first use, you must enable the battery and then set the Time, Date, and Location.
Enabling the Battery
1. Remove the pull tab (M) from the battery holder, if
present. See FIG. 1.
2. When the display shows 12:00 AM, the timer is
ready for initial set up. See FIG. 2. If 12:00 AM does
not display, perform a Factory Reset or see the
Troubleshooting section.
Note:
The timer may be set while unplugged. The display
turns OFF after 1 minute of inactivity to save battery.
Press any button to turn the display back ON.
Setting the Time, Date, and Location
Upon initial use, you can easily program these timer settings
in succession by completing the steps in this section.
1. Turn the selector knob (H) to select the correct hour of
the day. Press
SET
(D). Repeat to select the minute of
the day. See FIG. 2.
2. Turn the selector knob (H) to select the correct
YEAR
.
Press
SET
(D). See FIG. 3.
3. Turn the selector knob (H) to select the correct
MONTH
.
Press
SET
(D). See FIG. 3.
4. Turn the selector knob (H) to select the correct
DATE
.
Press
SET
(D). See FIG. 3.
5. Turn the selector knob (H) to select the correct Daylight
Savings Time setting. The options are OFF, US/CAN,
and Mex.
a. If in Hawaii or Arizona, select OFF. Press
SET
(D).
b. If you live in a part of Mexico that observes
US/Canada Daylight Savings Time, select US/CAN.
Press
SET
(D).
6. Turn the selector knob (H) to select the state you are in.
Press
SET
(D). See FIG. 4.
7. Turn the selector knob (H) to select the section of the
state you are in. Press
SET
(D). See FIG. 4.
8. Turn the selector knob (H) to select the time zone you
are in. Press
SET
(D). See FIG. 5.
9. Turn the selector knob (H) to adjust the DAWN offset
time (+/- 15, 30, 45 or 60 minute increments). Press
SET
(D). Offset is the amount of minutes you want the
lights to come on before (-) or after (+) DAWN or DUSK.
Repeat for the DUSK offset time. See FIG. 6.
10. Press
SET
(D) to finish setting up the timer.
FIG 1.
Removing the Pull Tab
FIG 2.
Setting the Time
FIG 3.
Setting the Date
FIG 4.
Setting the State
FIG 5.
Setting the Time Zone
FIG 6.
Setting the DAWN/DUSK Offset Time
