UVP 1.3 MPX HD 18X PTZ Camera
3 EN
Housing tab
Screw
Make sure the housing tab is closed and then PUSH the housing
into the pass-through hole. Hold the housing and fix it by screwing
the housing tabs down to the mounting surface
5. Insert the PTZ module into the housing:
Position the tabs on the PTZ module by aligning the arrow label on
the module with those on the housing (see below). The module
should firmly snap into position. If using a SDHC card, insert it into
the module before inserting the module into the housing.
6. Re-attach the bubble by screwing it to the housing.
7.
Pendant-mount camera
only
: Route the PTZ module cables
through the bracket.
Flush mount camera
only
: Install the trim ring. Align the trim ring
to the housing, and insert the fix-pins to the holes. Then rotate the
ring clockwise.
8. Connect the cables (see Figure 1).
Summary of Contents for UVP 1.3 MPX HD 18X
Page 8: ......
