2 / 2
P/N 1072896-EN
• REV
F
• ISS 16NOV16
Installation
To attach a plastic dome to a TVD-LWB-1 bracket:
Note
:
See
the l
ist of SKUs by hole position
on page 1, Hole A.
1.
Attach the bracket to the wall using the
four B screws
(drywall anchors are provided, if needed)
.
2.
Remove the bubble assembly
and attach the dome to the
bracket
using
three C
screws
into holes labeled A (see
Figure
1
for the location of the holes
).
3. Finish cabling and
adjust the
lens position, then attach the
bubble assembly
to the camera.
To attach a wedge camera to a TVD-LWB-1 bracket:
Note
:
See
the l
ist of SKUs by hole position
on page 1, Hole B.
1.
Attach the bracket to the wall by using the four B screws
(drywall anchors are provided, if needed)
.
2. Attach the adaptor plate to the
TVD
-LWB-1 bracket
using
the
four
A
screws
into holes B (see the
Figure
1
on page 1
for the location of the holes
).
3.
R
emove the
bubble assembly
and attach the camera to
the adaptor plate
with two screws (included with the
camera).
4. Finish cabling and
adjust the lens
position, then re-attach
the
bubble assembly
to the camera.
Legal information
Manufacturer
Interlogix.
2955 Red Hill Avenue, Costa Mesa, CA 92626
5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
Trademarks and
patents
The
trade names used in this document may be
trademarks or registered trademarks of the
manufacturers or vendors of the respective
products.
Certification
Contact information
For contact information, see www.interlogix.com or
www.utcfssecurityproducts.eu.
