© 2020 UTC Fire & Security Americas Corporation, Inc.
1 / 7
P/N R466-5569-
EN • REV B • DRAFT A03
RF-9011-07-1 Smart Repeater 433 MHz
Installation Sheet
PCB front view
PCB back view
EN: Installation Sheet
WARNING!
Electrocution hazard. To avoid personal injury or
death from electrocution, remove all sources of power and
allow stored energy to discharge before installing or removing
equipment.
You must be free of static electricity before handling circuit
boards. Wear a grounding strap or touch a bare metal surface
to discharge static electricity.
Description
The purpose of the repeater is to receive and retransmit
signals from wireless sensors, wireless keyfobs (only for 63bit
protocol), and other repeaters.
Depending on protocol settings, the repeater supports either
433 MHz 63bit sensors, or 433 MHz LoNa sensors, but not
both
. See “DIP switch settings” on page 2 for details.
Figures: Device layout
(1) 230 VAC power connector
(2) Battery
(3) Radio antenna for
transceiver 2
(4) Status LEDs
(5) DIP switch
(6) Power supply unit
(7) Diagnostic button
(8) Tamper switch
(9) Diagnostic connector
(10) Transceiver 1
(11) Transceiver 2
(12) Radio antenna for
transceiver 1
Symbol definitions
Item
Description
~
Alternating current
Class II equipment
Danger of electric shock
Installation guidelines
Installation only by a trained installer.
1. Mount and fasten the repeater to the wall with M4 flat
head screws.
2. Fasten the tamper screw.
3.
Connect power according to “Power options” on page 2.
4. Latch the housing cover so it locks securely into place.
5. Secure the housing with the protective screw at the side of
the housing cover.
Follow below guidelines when installing the repeater:
•
Before mounting the device, use D1 to D8 LEDs and
check signal strength and noise floor.
•
Strongly recommended at least 50 cm of clearance above
the enclosure.
•
Avoid areas with excessive metal or electrical wiring,
including furnace and utility rooms.
•
Avoid mounting in a location that exposes the module to
high humidity.
(1)
O
N
1
2
3
4
5
6
7
8
+
(2)
D1
D8
D3
D4
D5
D6
D7
D2
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(8)