- 12 -
Approved IFS SFP Transceivers
The MCR300-1T-2S Gigabit Media Converter supports both Single mode and Multi-mode SFP transceiver. The following list of
approved IFS SFP transceivers is correct at the time of publication:
UTC Model
SFP Description
S30-1SLC/A-10 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1310nm/1550nm, 10km , A End
S30-1SLC/A-20 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1310nm/1550nm, 20km, A End
S30-1SLC/A-60 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1310nm/1550nm, 60km, A End
S30-1SLC/B-10 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1550nm/1310nm, 10km , B End
S30-1SLC/B-20 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1550nm/1310nm, 20km, B End
S30-1SLC/B-60 SFP, LC Connector, Single Mode, Gigabit, 1 fiber, 1550nm/1310nm, 60km, B End
S30-2MLC
SFP, LC Connector, Multi Mode, Gigabit, 2 fiber,850nm/850nm, 550m
S30-2MLC-2
SFP, LC Connector, Multi Mode, Gigabit, 2 fiber,1310nm/1310nm, 2km
S30-2SLC-10
SFP, LC Connector, Single Mode, Gigabit, 2 fiber,1310nm/1310nm, 10km
S30-2SLC-30
SFP, LC Connector, Single Mode, Gigabit, 2 fiber,1310nm/1310nm, 30km
S30-2SLC-70
SFP, LC Connector, Single Mode, Gigabit, 2 fiber,1550nm/1550nm, 70km
S30-RJ
SFP, RJ-45, Gigabit, 100m
2.5.2 Media Chassis Installation
To install the Gigabit Media Converter in a
19-inch
width standard rack, follow the instructions described below.
Step 1
: Place your Gigabit Media Converter on a hard flat surface, with the front panel positioned towards your front side.
Step 2
: Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis, the Power LED of the Gigabit Media
Converter will turns ON.
Figure 2-5-2:
Insert a Gigabit Media Converter into an available slot
