1 P/N 466-5307
• REV A • ISS 15MAR17 ©2017 United Technologies Corporation
CDX-135Z
Wireless Smoke/CO Detector with Heat and
Freeze Sensor Installation Manual
Attention:
Please take a few minutes to thoroughly read this guide which should be
saved for future reference.
The CDX-135Z wireless smoke and carbon monoxide detector with heat and freeze
sensor is compatible with the following Interlogix learn mode panels: Simon®XT, Simon
XTI, Concord®4 (firmware version 4.7 or higher), Advisor®One and UltraSync
Description
The Interlogix CDX-135Z supervised photoelectric smoke and carbon monoxide (CO)
detector with heat and freeze sensors is a self-diagnostic Learn Mode wireless sensor
with wireless interconnection, 10-yr sealed battery and sensor life, built-in sounder,
diagnostic/status LED, integrated fixed temperature and rate-of-rise heat sensor and a
pre-freeze condition sensor.
The CDX-135Z uses a 319.5MHz transmitter for communication to the control panel
and a 915MHz transmitter for interconnection communication between networked
detectors. Up to 24 detectors can be a part of the same interconnected network. The
dual transmitter design ensures interconnection integrity is maintained independent of
control panel status. Because of this unique design the CDX-135Z is multi listed to UL
217, UL268, UL2034 and UL2075 requirements.
The combination alarm combines the detection capabilities of a photoelectric sensor
with that of an electrochemical sensor, which is used to detect CO. The highly accurate
electrochemical CO sensor uses sophisticated onboard microprocessor to effectively
