Note
: A green light flashes each time a number or
function button is pressed. A red and green light
flash each time a panic button is pressed.
1.
Notify the central monitoring station that (1)
you are testing the security system and (2)
not to dispatch emergency services.
Technical support, www.interlogix.com/customer-support
www.utcfireandsecurity.com or www.interlogix.com
Copyright © 2011 UTC Fire & Security Company. All rights reserved
2.
Arm and disarm the system with the
touchpad from various locations in order to
determine usable range.
3.
Press STATUS to check the current arming
level.
4.
Select Direct and Indirect to bypass sensors.
5.
Press and hold each panic button
until
the
red/green indicator light stops flashing and
the appropriate alarm sounds.
6.
Turn lights on or off (see system
documentation).
7.
Press and hold the buttons marked
1
and
2
at the same time to mute the touchpad.
Continue to hold the buttons until you hear a
series of confirmation beeps.
8.
Press various buttons to test the mute
feature.
9.
Press and hold the buttons marked
1
and
2
at the same time to turn off the mute
function. Continue to hold the buttons until
you hear a series of confirmation beeps.
10. Contact the central monitoring station after
you have finished testing the touchpad.
Mounting the touchpad
Test the wireless touchpad at a desired location.
Ensure that a clear RF signal exists between the
touchpad and control panel. After successfully
testing for a clear RF signal, you can mount the
touchpad as follows:
1.
Secure the touchpad mounting bracket to a
desired surface. Use the screws from the
accessory pack to mount the bracket (see
Figure 3 below).
Figure 3: Securing the mounting bracket
Screws
Mounting
Holes
2.
Attach the touchpad to the mounting bracket
by placing the touchpad bottom into the
bracket bottom. Press the touchpad into
place to ensure a secure fit (see Figure 4
below).
Figure 4: Attach to mounting bracket
Specifications
Model no.
60-597
RF frequency
319.5
Compatibility Concord,
Concord
Express, and Advent
security panels
Power requirements
One 3.0 V DC lithium
battery
Battery life
5 to 8 years
Storage temperature
-40° to 140°F (-34° to
60°C)
Operating
Temperature
10° to 120°F (-12° to
49°C)
Maximum Humidity
90% relative humidity,
non-condensing
Dimensions
2.1 x 0.86 x 6.1 in. (5.33 x
2.18 x 15.5 cm)
Regulatory information
Manufacturer
UTC Fire & Security Americas
Corporation, Inc.
1275 Red Fox Rd., Arden Hills,
MN 55112-6943, USA
FCC compliance:
This device complies with FCC Rules Part 15.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference that
may be received, including interference that may
cause undesired operation.
Changes or modifications not expressly
approved by Interlogix can void the user’s
authority to operate the equipment.
FCC ID No.: B4Z-861-HTTP
