Interline 57100253, Instruction Manual

Page: 18 / 37

6. WINTERIZE
1) Unplug the pump from the power source.
2) Close the shut off valves or block the flow of water al the pool inlet and return ports.
3) Disconnect the filtration system from the pool, drain the tank and hoses.
4) Place the handle on the central valve in position 7- “Winterize” to relieve the tension on
the spring and internal valve components.
5) Store the filter system in a location protected from frost and severely cold temperatures.
ln a garage or insulated storage shed is recommended.
parts or in the case of a complaint, please contact our customer service:
7. TROUBLESHOOTING
MALFUNCTION Cause Solution
Pressure gauge has
reading over 1 bar
Pressure is too low Hair and lint strainer basket is dirty;
Pump gels too little water
Clean the hair and lint strainer; check the
suction line and the water level
Air in the pump
Poor seal on the in-take side of the
pump.
Tighten hose clamps and connecting
Leaking Seal Defective C heck the seal, replace if needed
Pump does not run Not plugged in C heck the socket and power cord
G.F.C.1/ or main circuit breaker tripped Switch on the breaker (if it is immediately
tripped again, there is a defect in pump
or controls)
Pump motor defective R eplace the entire pump
Sand in Pool
If the sand is newly replaced, the under-
sized grains are still present
Backwash several limes until the
backwash water is clear (position 4)
Sand in Central Valve (from back-wash) P urge into drainpipe for 30 seconds
(position 6)
in-stalled
Check the separation wall for proper
positioning
Filter bottom strainer is damaged
Air in system
Loosen, but do not remove, the
allow any trapped air to escape. Tighten
the cover once ail of the air has escaped
EN EN