6
In this section we will configure port forwarding on the eSAM to access the controller from outside the network
1. First, I will need to put the controller and the eSAM on the same Subnet. The Subnet is usually described by
the first three numbers in the IP Address (192.168.1.1). According to the manual, the Danfoss controller has
the IP Address 192.168.1.100. So, we should change th
e eSAM’s IP Address to 192.168.1.1 so the subnets
match.
Open the
‘Network > LAN’
screen on the modem
And change IP1 to 192.168.1.1
. Press ‘Save’ to save your changes.
Please reboot the modem after changing the IP, to avoid confusing any devices already connected to it.
Note: It is possible to change the IP Address of the controller
– in this case you will have to set the eSAM to
match whichever IP was manually entered. Please contact Intercel technical support at
