Interactive Technologies Commander 2000, Owner'S Manual, Page: 31 / 61

31
Using and Programming the Magic
Key
The Magic Key feature allows you to quickly change the arming level of your system
from the panel without entering an access code and arming level. If you insert the Key into
the panel’s key slot while the system is armed to level 2 or 3, the panel disarms to level 1.
If you insert the Key later, the panel rearms to level 2 or 3, respectively. Before you can
use the Magic Key, you must first program the Key with a primary or temporary access
code.
When you program a Magic Key with an access code, you can use the Key to disarm the
system, and then rearm it to the previous arming level (level 2 or 3). A Key programmed
for primary access works as long as your primary access code is not changed. A Key pro-
grammed for temporary access only works for a limited number of days (00-99). You can
reprogram a temporary access Key at any time to increase or decrease the number of days,
or change it to a primary access Key.
Figure 4 . Inserting the Magic Key into the Slot
■
To program the Magic Key for primary access:
1. Enter primary ACCESS CODE + 8 + new primary ACCESS CODE.
The panel announces,
[new primary access code] OK
.
NOTE: You can enter your current primary access code in place of a new
primary access code if you do not want to change your code.
2. Insert the Key into the slot within 30 seconds of changing your primary access code
(see Figure 4).
3. Hold the Key in the slot until the panel announces, Memory OK .
P
O W E R
R
E A D Y
S
T A Y
A
W A Y
N
O
D
E L A Y
T
R O U B L E
1 2 3 4 5
6 7 8 9 0
B Y P A S S C O M M A N D
P O L I C E
F I R E
A U X S T A T U S
M A G I C K E Y
8 3 3 3 G 9 5 A . D S 4
Technical Manuals Online! - http://www.tech-man.com