3. Installation
—
Scape®
Tangible
Technical specifications are
st55-005
to change without notice.
Operating manual
Version 1.6 – Status: 12/2019
Page 11 of 27
poc: SFi
3.1.1.
Guidelines for housing the hardware
·
When installing a
Scape® Tangible
, keep a minimum space of 10 cm beneath the underside.
·
When installing the devices, make sure that all incoming and outgoing air flows in the same direction! Mixing the cold
and warm air reduces the cooling capability and thus the service life of all the devices.
·
Thermally separate the intake and exhaust openings of all actively ventilated units with a partition to prevent the cold
air from warming up
(4)
.
·
The intake opening of the enclosure
(2)
should measure at least the sum of the air intake openings of all the installed
devices (Scape® Ta Silent-PC = min. 200 cm²). The exhaust opening
(6)
should also be adjusted accordingly.
Circular or square openings are more suitable than narrow openings.
o
Scape® Tangible
= min. 150 cm²
o
Scape® Tangible
+ Silent-PC = min. 200 cm²
·
If the intake and exhaust openings of the enclosure cannot comply with the recommended size, the air flow have to be
additionally increased by installing active fans at the openings.
3.1.2.
Diagram for housing a Scape® Tangible
1
Scape® Tangible
2
Intake air opening (
Scape® Tangible
= at least 150 cm²)
3
Intake air chamber
4
Partition
5
Exhaust air chamber
6
Exhaust air opening (
Scape® Tangible
= at least 150 cm²)
mind.
10 cm
1
2
4
6
3
5
