STEREO TUNER
7
PT-9107SD
Rear Panel
Rear Panel
1. AC INLET
This terminal is connected AC input cord.
2. DC INPUT 24 VOLT
This input is for connection to a 24V DC power source and is not commonly used except in applications
requiring emergency operation via 24V DC.
3. FIXED OUTPUT CONNECTOR
This Mono Balanced Output has a fixed level that is not affected by the Output Level Control (located on
the front panel).
4. MONO VARIABLE OUTPUT CONNECTOR
This Mono Balanced Output has a variable level that is determined by the Output Level Control (located
on the front panel).
5. AM FM ANTENNA TERMINALS
The FM terminal accepts a 75 Ohm Coaxial cable that terminates at an FM antenna.
The AM terminal accepts the lead wires of the provided AM antenna (or other suitable antenna). Antenna
position may affect performance so it may be necessary to reposition the antenna for the best reception.
6. FUSE COVER
This fuse cover contain AC fuse, replace only with same type fuse when it is blown out. If it continuously
low, stop replacing fuse and refer servicing to qualified personnel.
7. DIGI-LINK ACCESS CONNECTOR
(The Digi-link contact terminal is only compatible with Inter-M code, preset, control 10, 20)
This connector interfaces with the DIGI-LINK remote control.
8. RESET BUTTON
The RESET button clears any microprocessor problems which may occur when the power is switched on.
If a malfunction occurs, switch the power off and press RESET for 2~3 seconds.
9. STEREO VARIABLE OUTPUT CONNECTOR
This Stereo Unbalanced Output has a variable level that is determined by the Output Level Control (locat-
ed on the front panel). This output can be either stereo or Mono as determined by the MONO/ST button
located on the front panel.
R
L
DC INPUT
24V
UNBAL / 75
Ω
LOOP
ANT.
L
R
STEREO
MONO(BAL)
MONO(BAL)
VARIABLE
FIXED
S
N
www.inter-m.com
OUTPUT
ANT
RESET
FM
AM
2
3
4
5
8
7
9
DIGI-LINK
1
6
PT-9107SD_E 2003.10.27 9:58 AM 페이지10
