Inter-m 5A0C828364DB-1, Operation Manual

Page: 10 / 20

POWER DISTRIBUTOR
8
PD-6359A
※
If BY PASS setting switches are ON more than 2 switches then the front panel of BY PASS LED is to blink
by 2 sec interval and AC power is to output by the order of SWITCHED 3
→
SWITCHED 2
→
SWITCHED
1. Please do not ON PASS setting switches more than 2 switches.
4. ADDRESS SWITCH
It is the switch setting up the device number. For the details of Equipment Setting, please refer to page 4.
5. LINK IN/OUT TERMINAL
It is the communication terminal for monitoring the status of service voltage. Link In terminal is connected to
the previous device, and Link Out terminal will be connected to the next device.
※
Caution: Communication error may occur if setting is performed incorrectly.
※ IN/OUT Terminals are all same.
6. TERMINATION SWITCH (LOAD/OPEN)
It is the switch which is set for stable data receiving/transmitting of link in/out.
For the details of Equipment Setting, please refer to page 4.
※ Caution: communication error may occur if it is not set correctly.
7. DC POWER OUTPUT TERMINAL (UNSWITCHED)
It is the terminal which supplies the power to the device operated by DC 24V.
8. REMOTE TERMINAL
This is Remote Terminal to be remotely operated PD-6359A. Please connect PD terminal at rear panel of
ECS-6216P our company’s model. Upon a contact is output from PD terminal of ECS-6216P and upon a
contact is input to remote terminal of PD-6359A then PD-6359A is to be operated automatically. Provided,
the remote control can be operated only the power switch is OFF position in the front panel.
9. DC POWER OUTPUT TERMINAL (DC OUTPUT, ONLY RACK)
It is the terminal supplying DC power to the rack system as rated 24V power output. It can be controlled with
front power switch ON/OFF.
PIN NO. Functions
1 RS-485 Data - A
2 RS-485 Data - B
3 RS-485 Data - Z
4 NA
5 GND
6 RS-485 Data - Y
7 NA
8 NA