Low V & -
A
Flange
B
2X
C
B 2X
D
2X
DRAWING NOT TO SCALE
Step 1; Remote Drivers:
Turn off Power Before
Installation.
Install Remote Drivers (A) and make
connections to AC power and Low Voltage
cables. Then run Low Voltage cables to future
position of Luminaire (B).
AC Power
Step 4; Install End Caps:
If your order is comprised
of stand alone fixtures, they will come with End
Caps (D) pre-installed. If it is a continuous run,
you will need to install the provided End Caps (D)
in the field, at the ends of each run of Luminaires
(B).
940-SM20LDL
Power feed hole
Step 3; Install Joiners:
If your order consists of
stand alone fixtures, skip this step. If not, connect
Luminaires (B) to each other using supplied
Joiner Kits (C). Slide Joiner into channel and
push Luminaires (B) together, then center Joiner
on joint and drive screws into Joiner.
Step 2; Prepare ceiling:
Mark the future position
of the fixture on the ceiling. Then, drill adequate
sized power feed hole
in ceiling which aligns with
cable of Luminaire (B).
410-381-1497 inter-lux.com
PAGE 2 OF 5
*Inter-lux reserves the right to make changes to this product and related installation instructions at any time without prior notice.
INSTALLATION INSTRUCTIONS
LOCATE AND REVIEW ANY CONSTRUCTION PLANS AND INTER-LUX RECORD DRAWINGS FOR ALL FIXTURE RUNS.
IT IS RECOMMENDED TO LOCATE AND LAY OUT ALL COMPONENTS FOR EACH FIXTURE "RUN". A FIXTURE RUN TYPICALLY CONSISTS OF JOINERS, LENGTHS OF HOUSING, AND ENDCAPS.
BE SURE TO IDENTIFY ALL CORRECT LENGTHS FOR EACH FIXTURE RUN.
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF
Inter-lux
. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF
Inter-lux
IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
WG-SM20LDL
INSTALLATION INSTRUCTIONS
Whitegoods 20 Linear Surface
CAUTION: CAUTION:
THIS IS AN ELECTRONIC DEVICE. CARE MUST BE TAKEN INTER-LUX IS NOT RESPONSIBLE FOR THE
DURING STORAGE AND HANDLING. STORE IN A CLEAN, COOL STRUCTURAL INTEGRITY OF THE BUILDING TO
AND DRY LOCATION. ELECTROSTATIC DISCHARGE (ESD) CAN SUPPORT THE LUMINAIRE. ADDITIONAL BACKING
HARM THIS PRODUCT. AVOID STATIC DISCHARGE WHILE MAY BE REQUIRED.
HANDLING THIS PRODUCT.
WARNING:
WARNING:
WARNING:
INSTALL PRODUCT IN ACCORDANCE
FAILURE TO COMPLY WITH THE
READ ALL SAFETY INSTRUCTIONS
WITH LOCAL AND NATIONAL ELECTRICAL
INSTALLATION INSTRUCTIONS MAY
INCLUDED WITH LUMINAIRE BEFORE
CODES BY A QUALIFIED ELECTRICIAN.
RESULT IN DEATH OR SERIOUS INJURY.
INSTALLING LUMINAIRE. SAVE
INSTRUCTIONS FOR FUTURE USE.
