background image

Do not place appliances which produce open fire in 
places exposed to the air flow from the unit or under the 
indoor unit.

  

It may cause incomplete combuston or deformation of the unit 
due to the heat. 
 

Do not install the air conditioner at any place where 
flammable gas may leak out.  

If the gas leaks out and stays around the air conditioner, a fire 
may break out.  
 

The appliance should not be used by children without 
supervision. 
 

The air conditioner consists of the indoor unit, the outdoor unit, 
the connecting pipe and the remote controller. 

 
 

This function is used to operate the unit temporarily in case you 
misplace the remote controller or its batteries are exhausted. 
Two modes including AUTO and FORCED COOL can be 
selected through the TEMPORARY BUTTON on the air-in grill 
control box of the indoor unit. Once you push this button, the air 
conditioner will run in such order: AUTO, FORCED COOL,  
OFF, and back to AUTO. 

AUTO

 

The OPERATION lamp is lit, and the air conditioner will run 
under AUTO mode. The remote controller operation is enabled 
to operate according to the received signal. 
 
FORCED

 

COOL 

The OPERATION lamp flashes, the air conditioner will turn to 
AUTO after it is enforced to cool with a wind speed of HIGH for 
30 minutes. The remote controller operation is disabled. 
  
OFF 
The OPERATION lamp goes off. The air conditioner is OFF 
while the remote controller operation is enabled.

 

Use the system in the following temperature for safe and 
effective operation. 

NOTE 

 
If air conditioner is used outside the above conditions, it 
may cause the unit to function abnormally. 
 
The phenomenon is normal that the surface of air 
conditioning may condense water when the relative 
larger humidity in room, please close the door and 
window. 
 
Optimum performance will be achieved within these 
operating temperature range. 
 
In heating mode,the temperature of the inlet water must 
be  under 75

ć

Water system operating pressuer: Max: 1.6MPa, Min: 
0.15MPa.  

The following should be noticed to ensure an economical 
operation. 

Adjust the air flow louver properly and avoid direct air flow to 
room inhabitants. 
 
Adjust the room temperature properly for a comfortable 
environment. Avoid excessive heating or cooling. 
 
Prevent direct sunlight during cooling operation by using 
curtains or blinds. 
 
Ventilate often. Extended use requires special attention to 
ventilation. 
 
Keep doors and windows closed. If the doors and windows 
remain open, air will flow out of your room causing a decrease 
in the cooling or heating effect. 
 
Never place objects near the air inlet or the air outlet of the unit. 
It may cause deterioration in the effect or stop the operation. 
 
Set the timer . 
 
If you don't plan to use the unit for a long time, please take the 
batteries from the remote controller. When the power is on, 
some energy will be consumed,even if the air conditioner isn't in 
operation. So please disconnect the power to save energy.  
 

owner's manual 

Function indicators on indoor unit display panel 

(figure 1)

    

Display panel 

NOTE 

This manual does not include Remote Controller 
Operations, see the<<Remote Controller Owner's 
manual>> packed with the unit for details.  

PRE-DEF indicator(cooling and heating type)  
or fan only indicator(cooling only type) 

Infrared signal receiver 

Operation lamp 

Timer indicator 

Alarm indicator 

Temporary button 

23(5$7,217,0(5'())$1$/$50

Frost indicator 

ː

If electrical appliances are disposed of in landfills or dumps, 
hazardous substances can leak into the groundwater and get  
into the food chain, damaging your health and well-being 

DISPOSAL

˖

Do not dispose this product as unsor- 

ted municipal waste. Collection of such waste sepa- 
rately for

special treatment is necessary. 

Do not dispose of electrical appliances as unsorted municipal 
waste, use separate collection facilities. 

Contact you local government for information regarding the 
collection systems available. 

Cooling operation 

Heating operating

(cooling only
type without)

Mode 

Temperature 

Outdoor 

temperature 

Room 

temperature 

water inlet 

temperature

0°C

̚

30°C

17°C

̚

32°C

30°C

̚

75°C

3°C

̚

20°C

-15°C

̚

24°C

0°C

̚

43°C

Do not place appliances which produce open fire in 
places exposed to the air flow from the unit or under the 
indoor unit.

 

It may cause incomplete combuston or deformation of the unit 
due to the heat. 

Do not install the air conditioner at any  place where 
flammable gas may leak out.  

If the gas leaks out and stays around the air conditioner, a fire 
may break out.  

The appliance should not be used by children without 
supervision. 

The air conditioner consists of the indoor unit, the outdoor unit, 
the connecting pipe and the remote controller. 

This function is used to operate the unit temporarily in case you
misplace the remote controller or its batteries are exhausted. 
Two modes including AUTO and FORCED  COOL can be 
selected through the TEMPORARY BUTTON on the air-in grill 
control box of the indoor unit. Once you push this button, the air 
conditioner will run in such order: AUTO, FORCED  COOL, 
OFF, and back to AUTO. 

AUTO
The  OPERATION lamp is lit, and the air conditioner will run 
under AUTO mode. The remote controller operation is enabled
to operate according to the received signal.

FORCED COOL 
The  OPERATION lamp flashes, the air conditioner will turn to 
AUTO after it is enforced to cool with a wind speed of HIGH for 
30 minutes. The remote controller operation is disabled. 
  
OFF 
The  OPERATION lamp goes off. The air conditioner is OFF 
while the remote controller operation is enabled.

1

2

3

Use the system in the following temperature for safe and 
effective operation. 

NOTE

1

2

If air conditioner is used outside the above conditions, it
may cause the unit to function abnormally. 

The phenomenon is normal that the surface of air 
conditioning may condense water when the relative
larger humidity in room, please close the door and 
window. 

Optimum performance will be achieved within these
operating temperature range. 

In heating mode,the temperature of the inlet water must 
be  under 75

ć

Water system operating pressuer: Max: 1.6MPa, Min: 
0.15MPa.  

The following should be noticed to ensure an economical 
operation. 

Adjust the air flow louver properly and avoid direct air flow to 
room inhabitants. 

Adjust the room temperature properly  for a comfortable 
environment. Avoid excessive heating or cooling. 

Prevent direct sunlight during cooling operation by using 
curtains or blinds. 

Ventilate often. Extended use requires special attention to
ventilation. 

Keep doors and windows closed. If the doors and windows
remain open, air will flow out of your room causing a decrease
in the cooling or heating effect. 

Never place objects near the air inlet or the air outlet of the unit. 
It may cause deterioration in the effect or stop the operation. 

Set the timer . 

If you don't plan to use the unit for a long time, please take the 
batteries  from the remote controller. When the power is on, 
some energy will be consumed,even if the air conditioner isn't in
operation. So please disconnect the power to save energy.  

owner's manual 

Function indicators on indoor unit display panel 

(figure 1)

    

Display panel 

NOTE

This manual does not include Remote Controller 
Operations, see the<<Remote Controller  Owner's 
manual>> packed with the unit for details.  

PRE-DEF indicator(cooling and heating type) 
or fan only indicator(cooling only type) 

Infrared signal receiver 

Operation lamp 

Timer indicator 

Alarm indicator 

Temporary button

23(5$7,217,0(5'())$1$/$50

23(5$7,21

7,0(5

'())$1

$/$50

Frost indicator 

ː

If electrical appliances are disposed of in landfills or dumps, 
hazardous substances can leak into the groundwater and get 
into the food chain, damaging your health and well-being 

DISPOSAL

˖

Do not dispose this product as unsor- 

ted municipal waste. Collection of such waste sepa- 
rately for special treatment is necessary. 

Do not dispose of electrical appliances as unsorted municipal 
waste, use separate collection facilities. 

Contact  you local government  for information regarding the 
collection systems available. 

Cooling operation

Heating operating

(cooling only
type without)

Mode 

Temperature

Outdoor 

temperature 

Room

temperature 

water inlet 

temperature

0°C

̚

30°C

17°C

̚

32°C

30°C

̚

75°C

3°C

̚

20°C

-15°C

̚

24°C

0°C

̚

43°C

Reviews: