5
FIRE
The Alarm Company may have linked smoke detectors to the control
panel. If activated the sounders will pulse.
Make sure that every one
leaves the premises
. When you are sure that it is safe to return,
proceed directly to keypad enter the user code. The sounders will stop.
Refer to page 7 to reset the alarm.
USER FUNCTIONS & OPTIONS
CODE CHANGE
The system has 8 user codes. The default user 1 code is
1
-
2
-
3
-
4
. There
may be times that you need to change your user code. To help you
remember your new code, write it down
before
changing it and after you
have successfully changed and memorised the code destroy the written
code. Remember, try not to use obvious codes such as the current year,
1-1-1-1 etc.
To change
user code 1
, enter your existing code then press
8
, followed
by
1
for user 1. Enter your new 4-digit code the keypad will give two
beeps.
If the panel does not accept your code then there may be a conflict with
another user code. The panel will abort the code change and retain the
old code. Three beeps will be heard from the keypad. Try again with a
different code.
To change
user 2 code
go through the above procedure but press
8
,
followed by
2
for user 2, then the required code. The other users are
changed in the same way using
existing code
,
8
,
user number
,
new
code
.
User code access levels
•
User 1 code can alter all user codes
•
Other users can only alter their own code
•
All codes have the same access authority
•
Code 8 is reserved for Duress
If for any reason you forget or mistype your master code (user 1) when
changing it, the Alarm Company will need to be contacted to reset the
panel codes.
DURESS
User code 8 is reserved to be enabled by the Alarm Company as a duress
code. When used it will operate normally as all other codes but will also
send a silent duress signal to the alarm monitoring station, see page 7.
USE WITH CARE.
FIRE
CODE CHANGE
USER CODE
ACCESS
LEVELS
DURESS