IntelliSAW IRM-48 Reader
Installation Manual
Page 19 of 28
IRM-48 Reader
910.00371.0001
4.3
H
UMIDITY
S
ENSOR
C
ONNECTIONS
The Humidity Sensor Connector is a 4 position male connector. The connector accepts 16-26
AWG wire. It is recommended that Ferrules be used for all terminating wires. The IntelliSAW
Humidity sensor is shipped with a cable assembly.
H-PWR
H-DAT
H-CLK
H-COM
M12 Connector
HUMIDITY
SENSOR
Figure 12: Humidity Connector
4.4
A
IR
I
NTERFACE
C
ONNECTIONS
The IRM-48 Reader supports up to 4 Air Interface Antenna connections (P1-P4). The Air
Interface Antenna connections on the Reader are female SMA connections. The Air Interface
Antenna’s connect to the Reader through RF cables with Male SMA Connectors on each end.
RF Cables are provided by IntelliSAW when purchasing air interfaces. Only IntelliSAW provided
antennas are suitable for the desired performance and for compliance with transmitter
authorizations.
