Installing Your Module
When installing or removing a module, always turn off
the power to the case and disconnect the power cable.
Failure to do so may result in serious injury or equipment
damage.
Ensure the 10-pin connector on the power cable is
connected correctly to the module before proceeding.
The red stripe on the cable must line up with the -12V
pins on the module’s power connector. The pins are
indicated with the label -12V, a white stripe next to the
connector, the words “red stripe”, or some combination of
those indicators. Some modules have shrouded headers
to prevent accidental reversal.
Most modules will come with the cable already
connected, but it is good to double check the orientation.
Be aware that some modules may have headers that
serve other purposes so ensure the cable is connected
to the correct one.
The other end of the cable, with a 16-pin connector,
connects to the power bus board of your Eurorack case.
Ensure the red stripe on the cable lines up with the -12V
pins on the bus board. On Intellijel power supplies the
pins are labeled with “-12V” and/or a thick white stripe,
while others have shrouded headers to prevent
accidental reversal:
If you’re using another manufacturer’s power supply,
check their documentation for instructions.
Before reconnecting power and turning on your modular
system, double check that the ribbon cable is fully seated
on both ends and that all the pins are correctly aligned. If
the pins are misaligned in any direction or the ribbon is
backwards you can cause damage to your module,
power supply, or other modules.
After you have confirmed all the connections, you can
reconnect the power cable and turn on your modular system. You should immediately check that all
your modules have powered on and are functioning correctly. If you notice any anomalies, turn your
system off right away and check your cabling again for mistakes.
XFADE 1U Manual
5