Palette Case
D. Link Connector
Use this 3-pin connector to attach either a Mixup module or a Pedal I/O module to the two ¼”
connectors on the top of the Palette.
●
Mixup : Connect the 3-wire
link cable (provided with your
Mixup module), between the
Link Connector on the
Palette circuit board and the
CHAIN-OUT connector on
your Mixup.
In this scenario, unbalanced
stereo audio from Mixup’s
output is sent out Palette’s
two Audio Jacks.
●
Pedal I/O 1U : Connect the
3-wire link cable (provided
with your Pedal I/O module),
between the Link Connector
on the Palette circuit board
and the one on your
Pedal I/O.
In this scenario, unbalanced
audio is sent out Audio
Jack 1 to your external signal
processor, and unbalanced
audio comes back from your
external signal processor into Audio Jack 2.
IMPORTANT : If you connect a module to the Links Connector, you should not connect a
module to the Audio Jacks Connector (described previously). Since both connectors access
the Audio Jacks on your Palette case, unexpected results may occur.
E. 5V Connectors
Connect these 5V connectors to any modules that require a 5V power source. You can also
use this to power an Intellijel USB Power 1U module, which (for example) is useful for
connecting a small USB gooseneck LED light.
Page 9
