G-Force
3
Warning: In case of an overload of internal temperature, a thermostat with an automatic
reset protection will suspend the operation of the motor. This device gives the user greater
safety of operation.
The unit has no heating element. Air is then heated by the power of motor .This allows
considerable energy savings compared to traditional dryers. The first daily use could thus
give the impression of cold air, but it will be warming up coming from the second drying
cycle.
The device has a system that prevents vandalism, for example if the photocell sensor is
deliberately covered. If this occurs, the dryer will work without interruption for about 35
seconds, then automatically cut out and revert to stand by operation. Once the obstruction
has been removed, normal function will resume in 3-4 seconds.
MANTAINANCE
Warning: Before performing any maintenance, please disconnect the appliance from the
network.
Clean this dryer using a soft cloth dampened with water and detergent.
To ensure the durability and reliability of this product, periodically check that the grid
inlet and outlet of the cone are not clogged by dust or any equivalent material
FILTER HEPA H13 filter paper
The HEPA filter inside the machine, if present, guarantees air will be cleansed of
excessive dust and dirt. The filter must be periodically cleaned with a jet of compressed air
at a distance of about 20 cm. It must be replaced after a maximum of 1000 hours of use in
conjunction with the cartridges motor brushes. The quality H13 HEPA filter paper, if
maintained in good condition and replaced as instructed will provide protection against
bacteria by removing up to 99.997% of airborne particles.
BRUSH MOTOR (carbon brushes)
The motor brushes cartridge in the drive unit has a life of 1000 hours (360,000 uses), of
effective operation. The duration of the brushes varies depending on the conditions of use
and of cleaning the filter and general maintenance of the appliance. It is needed to contact
the service in order to restore the brushes at the end of the cycle.
General warnings
Do not use this product for a different function from that to which it is intended :HAND
DRYER
• Do not leave the appliance exposed to atmospheric conditions such as rain, sun, etc..
• Make no changes of any kind to the device
• Do not obstruct the air outlet or mouth
• Do not insert any object into the grid or the outlet air
In case of failure and / or malfunction, remove the mains and consult with the
manufacturer or dealer
IMPORTANT INFORMATION
This product falls within the competence of the EC Directive 2002/96 (WEEE) on disposal
Summary of Contents for g-force
Page 1: ...G Force user manual ...
