SBSC11Q Four channel SLA Battery Charger
Operator Manual
6 Display Brightness
The equipment has the facility to increase or decrease the intensity of each display from dim
to extremely bright. The following procedure has to be followed to perform this operation.
Ensure the the channel to be changed is not in RUN mode.
Using a small non metallic probe smaller than 2.0mm insert this into the small hole
between the START and STOP buttons, about 10mm of travel will take place before an
obstruction is met, apply a small amount of force to operate the internal switch, while
pressed the display will appear to freeze, this is normal.
Keep the pressure applied until the display shows “FUNC”, (about 5 seconds) at this
point release the pressure.
The display will then show “
CLV
”.
Press the FUNC button two times so the the display goes from “
CLV
” to “
CLA
” to
“
DSP
”.
With the display showing “
DSP
” press the START button.
The display will show “
XXX
”.
Use the START button and STOP button to either increase or decrease the display
brightness.
Once the correct brightness has been achieved press the FUNC button to store the
setting.
The display will then show “
CLV
” again.
Press the STOP button to return to normal operation mode.
This procedure has to be performed individually on each channel.
Doc: DWG1057-09-R2 SBSC11Q Operators manual.odt
Page 10 of 18
Copyright Material of Intelligent Charging Limited © 2018
Printed On : 17/07/19