8
DISCLAIMER: Please make sure that the length of the drain line does not exceed 1829mm. In the event that a pump is used, make sure it has a
capacity exceeding 80GPH. Intelligent Appliances will not be responsible for any losses arising from usage or failure of any additional devices
connected to the unit for facilitation of plumbing or drainage. Please refer to local codes for electrical and plumbing installation.
①
Mains Water in Connection (Min 30psi required)
Use the inline filter & braided mains hose to connect to your mains water
connection. The hose comes with a standard
3/8”
compression fitting.
②
Drain out connection
Connect the drain hose
(1/2”
to
3/4”
hose connection) to your drain which
should be no further than 1829mm from the Cultivator and 610mm up from
the floor.
③
Power connection
Connect the Cultivator to a standard 240V socket
-
outlet. The electricity plug
should be no further than 610mm away from the unit and should run out on
the same side as the water and drain hose. The wall receptacle is non
-
replaceable.
④
Hole size for all connections
Use a
4”
hole saw and remove part of the bottom shelf of the cabinet adjacent
to the Cultivator where all the connections run from.
⑤
Adjustable feet
Twist the Cultivators feet to adjust the heigh for levelling the unit.
Leave 1
½
”
clearance gap for the door swing and handle when
installing the Urban Cultivator adjacent to a wall.
Water in, Drain out & Electricity connections run out from one side
only, the left.
