3
INTRODUCTION:
The MB-900 Motion Sensor is designed to activate upon any physical movement of the
sensor. It has an integrated CR-1225 battery pack which allows for a very small form
factor that can be easily hidden / attached to most objects.
When activated, the MB-900 transmits a wireless RF signal to any Intellicam receiver.
CONTROLS AND INDICATORS:
BATTERIES:
The MB-900 has an integrated battery pack holding 2 each CR-1225 lithium batteries.
Make sure to check for fully charged batteries and replace if necessary.
PROGRAMMING BUTTON:
The MB-900 has a programming button. This allows the user to abort Range Test Mode,
program Sensor ID, or program a Sensor Sensitivity.
RED LED:
The RED LED is used for programming and as an alarm indicator. It only illuminates
during the Range Test Mode or when an alarm occurs during the Detection Mode for the
first 10 minutes. After 10 minutes, the RED LED turns off for covert reasons.
ANTENNA:
The flexible antenna allows for UHF propagation of the RF signal.
Programming Button
Rubber Boot
Opaque Cap
Battery Holder
Antenna
Red LED
