DocRef#0460601
CNS-4G - User Guide
Page 6
Chapter 4
–
RX Receiver LED Indicators
1. Upon power up you will see 3
RED
LED’s
on the RX Receivers illuminate as in Figure
1.
The LED’s will only stay fully lit for about 2 seconds.
You may see the
RED LED’s
flash periodically for the first 5 minutes while the receivers are in Range Test mode.
When you power up the Gateway and a sensor at the same time, they will communicate
with each other to help set up your perimeter. You know that you are within sensor
range when the R
eceiver’s
RED
LED’s
continue to blink.
2. If you trigger the CNS-4G with Sensor ID-2 while the receivers are still in Range Test
mode. The LED’s will look like figure 2.
The two
GREEN
LED’s
indicate Sensor ID-2. If
you use Sensor ID-1, two
BLUE
LED’s
will light up.
3. Figure 3 shows what the
GREEN
LED’s
will look like if you trigger the CNS-4G with
Sensor ID-2, after the range test mode is over and the receivers are standby mode.
Figure 1. Figure 2. Figure 3.
