Intelix
DIGI-HD-8X8
Installation Manual
10 www.intelix.com
Included Remote Control
The DIGI-HD-8X8 includes a wireless remote control
for switching inputs to the various outputs. Each output
is represented by a bank of buttons on the remote
control.
1.
Determine which output you wish to change.
2.
On the determined output, select the
forward
or
reverse
button until the desired source is displayed.
IR Remote Control
The DIGI-HD-8X8 supports remote control through a front panel IR sensor and
a rear panel 1/8” (3.5 mm) input jack.
1.
If controlling the DIGI-HD-8X8 through the 1/8” (3.5 mm) input jack on
the rear panel, connect the IR cable directly to the matrix.
2.
If controlling the DIGI-HD-8X8 through the IR sensor on the front panel,
place an IR emitter directly over the front panel sensor.
IR Emitter Mounting Tips
¾
Surrounding electrical equipment may be producing high
levels of IR noise. Plasma TVs and compact fluorescent lights
are known polluters. Shield the outside of the emitter and the
hardware’s IR window with electrical tape.
¾
Verify the emitter is directly on the hardware’s IR window
and directly over the IR sensor. Operation may be intermittent
if the emitter is too far away from the sensor.
¾
Clean the DIGI-HD-8X8 IR sensor window with an alcohol-
based cleaner before applying the emitter to guarantee
adhesion.
¾
Should the emitter not adhere to the DIGI-HD-8X8 sensor
window, apply a small drop of glue to the adhesion pad on the
emitter and re-apply.
Note:
Operation of the rear panel IR input will disable the front
panel IR sensor.
