13
Intel® RAID Controller SRCSASPH16I Hardware Guide
Technical Specifications
The design and implementation of the Intel
®
RAID Controller SRCSASPH16I minimizes
electromagnetic emissions, susceptibility to radio frequency energy, and the effects of
electrostatic discharge. See the appendices for regulatory marks and certifications.
J6
Dirty Cache LED
Header
SFF8087
For connection to enclusure LED. When lit,
indicates the data in the cache has not been
written to disk.
J9
Internal SAS/SATA
port connector,
ports 4-7
SFF8087
Connection to SAS/SATA devices.
J11
Mode 0 select
2-pin
connector
No jumper is required for normal operation.
Setting the controller to Mode 0 holds the I/O
processor in reset for firmware recovery.
• "No Jumper = Normal operational mode.
• "Jumper = Mode 0 for firmware recovery,
requires a firmware recovery utility and
firmware image file.
J12
Universal
Asynchronous
Receiver/
Transmitter (UART)
4-pin
connector
For factory and debug use.
J13
Internal SAS/SATA
port connector,
ports 0-3
SFF8087
Connection to SAS/SATA devices.
J14
Drive Fault LED
Header (0-7)
8x2 header
LED signal support for front panel drive fault per
port (0-7).
J15
Port activity LED
header (0-7)
8x2 header
LED signal for activity per port for 0-7 ports.
J16
Intel
®
RAID Smart
Battery Connector
20-pin
connector
Cable connector for the extrernal battery pack.
This connector is located on the back side of the
board.
J17
Keyed I
2
C
connector
3-pin
connector
Out-of-band enclosure management (SES2).
J18
Keyed I
2
C
connector
3-pin
connector
Out-of-band enclosure management (SES2).
Table 1. Jumper Descriptions
Jumper
Description
Type
Comments