Intel® RAID Controller SRCSAS18E User’s Guide
10
Quick Installation
The following steps are for quick RAID Controller SRCSAS18E installation. These steps
are for experienced computer users/installers. “Detailed Installation” contains the steps for
all others to follow.
1. Turn power off to the system and all hard disk drives, enclosures, and system
components.
2. Remove the power cord from the server.
3. Follow the insructions in the server documentation to open the server chassis.
4. Check the jumper settings and memory module on the RAID controller.
5. Install the RAID Controller SRCSAS18E in the server and connect SAS or SATA
devices to it. Ensure that the cables you use conform to all specifications.
6. Perform a safety check.
— Ensure that all cables are properly attached.
— Ensure that the RAID Controller SRCSAS18E is properly installed.
— Close the server chassis.
7. Reconnect power cable and turn on power.
Detailed Installation
This section provides detailed instructions for installing a RAID Controller SRCSAS18E.
1. Unpack the Storage Adapter
Unpack and remove the RAID Controller SRCSAS18E. Inspect it for damage. If it
appears damaged, or if any items listed below are missing, contact your Intel sales
representative. The RAID Controller SRCSAS18E is shipped with:
— The
Resource CD
, which contains drivers for supported operating systems, an
electronic version of this
User’s Guide
, and other related documentation
— A license agreement
2. Power Down the Server
Turn off the computer and remove the AC power cord. Remove the server chassis
cover. Refer to the server documentation for instructions.
3. Check the Jumpers
Ensure that the jumper settings on the your RAID Controller SRCSAS18E are correct.
See Chapter 3 for a diagrams of the RAID Controller SRCSAS18E.
Note: The jumpers are set at the factory and probably do not need to be changed.
4. Check the Memory Module
